Sony VPCJ117FX - Manual (Page 2)

VPCJ1 Series Optical Disk Drive
Replacement Instructions
P/N 989201985 Rev. B 2/3
Step 4. Using the enclosed magnetic
screwdriver, loosen the two (2) screws
securing the ODD Bay. These screws
cannot be completely removed. They
will stay enclosed in the assembly. Step 5. Gently pull the ODD tray out
so that it is completely exposed. Step 6. Move your fingers down to
the base of the ODD Assembly and
gently pull to remove the entire
Assembly.
ODD Disassembly
(Steps 7-10)
Step 7. Identify the four (4) side screws
that secure the ODD Brackets to the
ODD.
Step 8. Remove the screws &
Brackets
Put the ODD Brackets and screws
aside for transfer to the new ODD.
Step 9. Position the new ODD (Label
side down) and identify the correct
bracket with the corresponding ODD
side (as shown). Take note of the
different shapes for each bracket and
the proper alignment of the screw
holes.
Step 10. Using the ODD Screws, install
the ODD Brackets onto the new ODD.
NOTE: After installation, all brackets
should sit flush.
ODD Installation
(Steps 11-13)
Step 11. Align the ODD assembly
properly (label side down) and slide
into the computer.