Sony PCV-RS Series Hard Disk Drive (Replacement Instructions) - Manual (Page 2)

PCV-RS Series Hard Disk Drive
Replacement Instructions
P/N T99860136 Rev. C 2/2
Ensure that all 4 holes (2 on each
side) are in alignment
Step 4 . Proceed to disconnect the IDE Cable [1] and Power
Cable [2] from the Hard Drive. IMPORTANT! Some force may be
required to initiate the removal of the cables. Take caution not to
damage the cables.
Pull with equal force on both sides of each
cable to remove them as shown above.
Step 5 . Using the enclosed magnetic screwdriver, remove
the marked screw as shown on the picture. With one hand hold
the bracket enclosure while pulling the complete assembly out
of the unit.
Step 6 . Using the enclosed magnetic screwdriver, remove the
four (4) screws that secure the Hard Drive into the bracket
enclosure.
IMPORTANT! Before proceeding, take note of original
position of the Drive inside the bracket. Slide out the original drive.
Step 7 . Slide New Hard drive inside bracket with all holes in
alignment. Reinstall the four (4) screws previously removed,
securing new drive into the bracket.
Step 8 . [A] Reinstall the bracket enclosure being careful to
align the guides. Hold the bracket in place and reinstall the screw
previously removed. [B] Proceed to Reconnect the Hard Drive
cables into their original position.
Step 9 . Lower the cover onto the unit, Ensure that tabs on
the bottom edge into the base of your computer. Compress
both sides of the cover and push forward while holding the front
of your computer. Reinstall the three (3) screws removed in
step 1.
2
1
Align tabs
on both sides of
cover
[B] [A]
[1]
[2]
1
Remove
screw