Sony VGN-AW125J - Manual (Page 2)

VGN-AWxx Series Hard Disk Drive
Replacement Instructions
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N 994660300 Rev. A 2/3
Step 5. Using the enclosed magnetic
screwdriver, remove the screw securing the
hard disk drive access cover. Step 6. Remove the HDD access cover by
sliding it in the direction of the arrows
shown above. Step 7. Locate the two HDD assemblies.
(HDD 1 Removal) Steps 8- 9
Step 8. Using the enclosed magnetic
screwdriver, remove the three (3) screws
securing the HDD 1 assembly.
Step 9. To remove the drive, detach the
HDD 1 from the connector in the direction
shown. Some force may be needed to
unlock the HDD from the connector. Lift the
drive by holding on the black plastic tabs to
remove it completely. (HDD 1 Reinstallation) Steps 10-11
Step 10. Replace the old HDD 1 assembly
with the new one. Carefully place the HDD
assembly in the HDD bay.
Step 11. Verify that the new HDD 1
assembly is properly secured to the
connector. Reinstall the three (3) previously
removed screws to secure the HDD 1
assembly in place. (HDD 2 Removal) Steps 12-13
Step 12. Using the enclosed magnetic
screwdriver, remove the three (3) screws
securing the HDD 2 assembly.
Step 13. To remove the drive, detach the
HDD 2 from the connector in the direction
shown. Some force may be needed to unlock
the HDD from the connector. Lift the drive by
holding on the black plastic tabs to remove it
completely.
HDD 1 HDD 2