Sony MSAC-USM1 - Manual (Page 21)

21-US
– When using Windows 98SE/Windows Me –
1
Double-click the “System” icon on the “Control Panel.”
The “System Properties” screen appears.
2
Check if the device driver has already been installed.
1 Click the [Device Manager] tab on the “System Properties” screen.
2 Double-click [Universal Serial Bus Controller].
3 Check whether [? MSAC-USM1] preceded by the “?” symbol is
shown.
3
Delete the driver if installed.
If you use the procedure described in Step 2 and find that [? MSAC-
USM1] is shown under “Universal Serial Bus Controller,” a separate
device driver has already been installed.
Use the following procedure to delete this driver.
Do not delete other devices than [? MSAC-USM1].
1 Click on [? MSAC-USM1].
2 Click on [Remove]. The “Confirm Device Removal” screen appears.
3 Click the [OK] button. The device is removed.
4 Restart your computer after disconnecting this unit from the
computer.
Install the device driver again by performing the procedure from
Step 1 described on page 13.
P Note
If you delete other devices than [? MSAC-USM1], your computer may no
longer operate normally.