Sony VGC-RA837G - Manual (Page 2)

VGC-RA8xx Series Hard Disk Drive
Replacement Instructions
P/N 994629200 Rev. C 2/2
Ensure that all 4 holes (2 on
each side) are in alignment
Step 4 . Proceed to disconnect the serial ATA cable [1] and
power cable [2] from the hard drive. IMPORTANT! Some force
may be required to initiate the removal of the cables. Take
caution not to damage the cables.
Pull with equal force on both
sides of each cable to remove them as shown above.
Step 5 . Release the HDD bracket enclosure by pulling the
black handle as shown. Some force may be required to
unlock the handle. Slide the complete HDD bracket
enclosure out of the unit.
Step 6 . Using the enclosed magnetic screwdriver, remove
the four (4) screws that secure the hard drive into the bracket
enclosure.
IMPORTANT! Before proceeding, take note of
original position of the drive inside the bracket. Slide out the
original drive.
Step 7 . Slide new hard drive inside the bracket
enclosure with all holes in alignment. Reinstall the four
(4) screws previously removed, securing new drive into
the bracket.
Step 8 . [A] Reinstall the HDD bracket enclosure being
careful to align the guides. Some force may be required to
slide the HDD bracket enclosure into the unit. [B] Lock the
black handle in place.
Step 9 . Reconnect the serial ATA cable [1] and power
cable [2] to the hard drive. Reinstall side panel removed
in step 2. Connect your PC and continue with the
recovery instructions. Return the old hard drive to Sony
following the included shipping instructions.
[A]
[1]
CAUTION!
Sharp Edge
Notice the original position of the
handle and HDD
Notice position of the handle
and pin’s orientation
[B]
CAUTION!
Sharp Edge [2]
[2]
[1]