Sony VPCJ113FX User Manual
Page 2
VPCJ1 Series Hard Disk Drive
Replacement Instructions
P/N
989201986
Rev. B
2/3
Step 4. Using the enclosed magnetic
screwdriver, loosen the three (3) screws
securing the Hard Drive Assembly.
These screws can not be completely
removed. They will stay enclosed in
the assembly.
Step 5. Grasp the sides of the Hard
Drive Assembly and lift. Do not
completely remove the assembly at
this step.
Step 6. Carefully turn the Hard Drive
Assembly over to disconnect the Data
and Power Cables from the assembly.
To release the Data Cable, push the
metal tab and pull the Cable to the
right. To release the Power Cable just
pull to the right. Remove the assembly.
Step 7. Identify the (4) side screws that
secure the bracket to the Hard Drive.
Step 8. Holding the edge of the Hard
Drive, remove each screw. Put aside
the Bracket Screws to secure the
Bracket to the Hard Dive later in the
procedure.
Step 9. Set the old Hard Drive aside.
Step 12. Re-install the four (4) Hard
Drive Bracket screws to secure the
Hard Drive bracket to the New Hard
Drive.
Step 10. Place the new Hard Drive next
to the Hard Drive Bracket as shown.
Step 11. Place the Hard Drive bracket
over the new Hard Drive.
Hard Drive Disassembly
(Steps 7-12)
Lift To Remove
Old Hard Drive
New Hard Drive