Sony PFM-42X1S - Manual (Page 79)

23
(GB)
Using On-screen Menus
Sync Mode
Sets the mode according to the signal input at pin 13
of the RGB/YUV IN. Signals can be set only to 575/
50I or 480/60I.
H/Comp: When a horizontal signal or a composite
synchronous signal* is input
Video: When a video signal is input
*Depending on the level of the composite
synchronous signal, the image may not be displayed
correctly. In that case, change the Sync Mode
setting.
Input signal and Synchronous mode settings
PIN Signal input over the D-sub
Synchronous
mode setting
13
480/60I, 575/50I Composite Video
Composite Sync
13/14 H Sync/V Sync
2 Sync On Green
See “Pin assignment” on page 52 (GB) for more
information on the pin assignments of RGB/YUV IN.
Notes
• There are some inputs for which only synchronizing
signals can be selected. In this case, an image will
not be displayed even if a video signal is input to the
13 pin connector. Input horizontal/vertical
synchronization signals through the 13 or 14 pin
connectors, or input Sync On Green signals through
the RGB connector.
• With Sync On Green, if the unit is not set to accept
synchronizing signals, the image will not be
displayed.
• Sync Mode settings cannot be carried out using
option boards.
• This unit does not support the three value sync
format of composite sync and 576/60P.
Initial Setup menu
You can select the on-screen language and the color
system, and set the MENU Function.
MENU
MENU S e l e c t E n d
I n i t i a l S e t u p
L a n g u a g e :
C o l o r S y s t e m :
F u n c t i o n :
E n g l i s h
O n / O f f
S e t / ENTER
Language
Selects the on-screen language (Japanese, English,
German, French, Spanish, or Italian).
For details, see “Selecting the On-screen Language” on
page 42 (GB).
Color System
Selects the input signal.
Auto: to display NTSC, PAL, SECAM/NTSC4.43
or NTSC/PAL-M/PAL-N signals
NTSC: to display NTSC signals
NTSC4.43: to display NTSC4.43 signals
PAL: to display PAL signals
SECAM: to display SECAM signals
PAL-M: to display PAL-M signals
PAL-N: to display PAL-N signals
PAL60: to display PAL60 signals
When the Color System is set to “Auto,” an additional
color system capable of automatic detection is set in
the level below.
• Automatic detection of NTSC/PAL/SECAM/
NTSC4.43
• Automatic detection of NTSC/PAL-M/PAL-N
Note
This can only be set when a video signal is being
received.
MENU Function
Selects the operation when the menu key is pressed.
On/Off: The menu display toggles between on and
off each time the menu key is pressed.
Return: The cursor returns to the previous level
each time the menu key is pressed.
Video signal
Synchronizing
signal