Sony KDL-55EX500 - Manual (Page 17)

17
G
e
tting
Started
2
Secure the TV to the stand.
Except KDL-32FA600 model
Use the optional hardware listed below (not supplied):
• M4 × 16 mm anchor bolt (screwed into the TV’s Table-Top Stand).
• A screw or similar (attach it to the TV stand).
• Rope or chain (strong enough to support the weight of the TV). Make sure that there is no
excess slack in the rope or chain.
An alternative way to secure the TV is with an optional Sony Support Belt Kit.
KDL-32FA600 model only
Use an optional Sony Support Belt Kit.
3 Anchor the TV to the wall.
Use the hardware listed below (not supplied).
• Two anchor bolts, size M6 × 10-12 mm. Screw the bolts into the top-most wall-mount holes
located on the rear of the TV.
• Rope or chain (attach to one anchor bolt).
• Wall-anchor (attach to the wall stud) strong enough to support the weight of the TV (pass
the rope through the wall-anchor, then attach to the other anchor bolt).
Screw hole on the
Table-Top Stand
Anchor bolt
Screw
Wall-mount
holes
Anchor bolts
Wall-anchor
Rope or
chain
• Contact Sony Customer Support to obtain the optional Support Belt Kit by providing your TV
model name.
For United States call: 1-800-488-7669 or visit: www.sony.com/accessories
For Canada call: 1-877-899-7669
• Measure 2 provides minimal protection against the TV toppling over. For further protection,
follow all three measures recommended above.
• If an electric screwdriver is used, set the torque to tighten at approximately 1.5 N·m {15 kgf·cm}.