Sony KDL-55EX500 - Manual (Page 18)

18
Running Initial Setup
During initial setup, you will perform the following:
• Set the language for the On Screen Display (OSD) text
• Choose your viewing environment
• Scan for digital and analog channels
Complete your cable connections before beginning the Initial Setup. Refer to the Quick Setup
Guide (supplied) for sample connection diagrams.
3 Auto Program will scan for available channels from the signal source directly connected to
the TV’s CABLE/ANTENNA input. Follow the help text provided on the screen to run the
Auto Program.
1 Turn on the TV. The Initial Setup screen will
appear.
2 Use the remote control buttons described below to
navigate through the Initial Setup.
V/v/B/b buttons:
Allow you to navigate and highlight options where applicable.
button:
Allows you to select the highlighted option and advance to the next screen.
Confirm Confirm
Please select your language:
English
Español
Français
Initial Setup
Confirm Confirm
• Select Cancel to stop or cancel the Auto Program. The Auto Program can be done at later
time. To run Auto Program at a later time, press MENU, select Settings, and then select Auto
Program under Channel settings.
• Connect either your cable or antenna to the TV (you can connect both using an A-B RF switch (not
supplied)); for more details see page 11.
• Select your preferred aspect ratio for the screen display. Press WIDE to select Wide Mode, or press
MENU and select Settings, and then set Auto Wide to On under the Screen settings. For more
details, see page 27.