Sony RMT-840 - Manual (Page 73)

Du
b
b
in
g
/E
d
itin
g
Dubbing/Editing 73
Dubbing to another tape
1
Connect the recording device to your
camcorder (p. 70).
2
Prepare the recording device.
• Insert a cassette for recording.
• If the recording device has an input
selector, set it to the input mode.
3
Prepare your camcorder for playback.
• Insert the recorded cassette.
• Set the POWER switch to VCR.
4
Start the playback on your camcorder,
and record it on the VCR.
Refer to the operating instructions supplied
with your VCR for details.
5
When the dubbing is finished, stop
your camcorder and the VCR.
b Note
• When you use an i.LINK cable, the recorded picture
becomes rough when a picture is paused on your
camcorder while recording it to a VCR.
• Pictures recorded in the HDV format are not output
from the HDV/DV jack during playback pause or
in playback modes other than normal playback.
• When you use an i.LINK cable, you cannot record
the picture and sound separately.
z Tip
• The i.LINK lamp, HDV or DV, on the HDV/DV
jack holder will light up and indicate the format of
the output signal when you use an i.LINK cable.
• When you use an i.LINK cable, the video and sound
signals are transmitted digitally, producing high
quality pictures.