Step 2: connecting the projector, Side view – Sony VPL-HS20 User Manual
Page 13
Step 2: Connecting the Projector
Con
n
ect
ions a
n
d
P
repar
ati
o
n
s
13
GB
Side view
Step 2:
Connecting the
Projector
When making connections, be sure to do the
following:
• Turn off all equipment before making any
connections.
• Use the proper cables for each connection.
• Insert the cable plugs properly; plugs that are not
fully inserted often generate noise. When pulling
out a cable, be sure to pull it out from the plug, not
the cable itself.
• Refer to the operating instructions of the connected
equipment.
• When you connect your projector to PJ MULTI or
DVI connector, select the input signal with the
“Input-A Signal Sel.” or “DVI Signal Sel.” setting in
the SET SETTING
menu. (
Note
Before you change the “DVI Signal Sel.” setting, disconnect the
DVI cable and turn off the digital tuner, etc.
------------------------------------------------------------------------------
• HDMI, HDMI logo and High-Definition Multimedia Interface
are trademaarks or registered trademarks of HDMI Licensing
LLC.
134.2 (5
3
/
8
)
368.5 (14
5
/
8
)
216.6 (8
5
/
8
)
62.1
(2
1
/
2
)
61.5
(2
1
/
2
)
217.2 (8
5
/
8
)
234.3 (9
1
/
4
)
Front of the cabinet
Center of the lens
Unit: mm (inches)