Sony ICF-CS10IP User Manual

Fm/am clock radio, Icf-cs10ip operating instructions, Owner’s record

Advertising
background image

Owner’s Record

The model number and the serial number are located on the

bottom.

Record the serial number in the space provided below. Refer

to them whenever you call upon your Sony dealer regarding

this product.
Model No. ICF-CS10iP

Serial No. ________________________________

For customers who purchased this product in the

USA

Please register this product on line at

http://www.sony.com/productregistration.

Proper registration will enable us to send you

periodic mailings about new products, services,

and other important announcements. Registering

your product will also allow us to contact you

in the unlikely event that the product needs

adjustment or modification. Thank you.

WARNING

To reduce the risk of fire or electric shock, do

not expose this apparatus to rain or

moisture.

To reduce the risk of fire, do not cover the

ventilation of the apparatus with newspapers,

tablecloths, curtains, etc. And do not place lighted

candles on the apparatus.

To reduce the risk of fire or electric shock, do not

expose this apparatus to dripping or splashing,

and do not place objects filled with liquids, such

as vases, on the apparatus.
Do not install the appliance in a confined space,

such as a bookcase or built-in cabinet.
Do not expose the batteries (battery pack or

batteries installed) to excessive heat such as

sunshine, fire or the like for a long time.
As the main plug is used to disconnect the unit

from the mains, connect the unit to an easily

accessible AC outlet. Should you notice an

abnormality in the unit, disconnect the main plug

from the AC outlet immediately.
The unit is not disconnected from the AC power

source (mains) as long as it is connected to the

wall outlet, even if the unit itself has been turned

off.
The nameplate and important information

concerning safety are located on the bottom

exterior.
You are cautioned that any changes or

modifications not expressly approved in this

manual could void your authority to operate this

equipment.
CAUTION

Danger of explosion if battery is incorrectly

replaced. Replace only with the same type.

This symbol is intended to alert the user

to the presence of uninsulated “dangerous

voltage” within the product’s enclosure that

may be of sufficient magnitude to constitute

a risk of electric shock to persons.
This symbol is intended to alert the user to

the presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the appliance.

NOTE

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection

against harmful interference in a residential

installation. This equipment generates, uses and

can radiate radio frequency energy and, if not

installed and used in accordance with the

instructions, may cause harmful interference to

radio communications. However, there is no

guarantee that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning

the equipment off and on, the user is encouraged

to try to correct the interference by one or more

of the following measures:

— Reorient or relocate the receiving

antenna.

— Increase the separation between the equipment

and receiver.

— Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

— Consult the dealer or an experienced radio/TV

technician for help.

WARNING
 Replace the battery for the clock backup with a

Sony CR2032 lithium battery, and the battery

for the remote commander with a Sony CR2025

lithium battery. Use of another battery may

present a risk of fire or explosion.

 Battery may explode if mistreated. Do not

recharge, disassemble or dispose of in fire.

 Dispose of used battery promptly. Keep away

from children.

Important Safety

Instructions

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near water.

6) Clean only with dry cloth.

7) Do not block any ventilation openings.

Install in accordance with the manufacturer’s

instructions.

8) Do not install near any heat sources such as

radiators, heat registers, stoves, or other

apparatus (including amplifiers) that produce

heat.

9) Do not defeat the safety purpose of the

polarized or grounding-type plug. A polarized

plug has two blades with one wider than the

other. A grounding type plug has two blades

and a third grounding prong. The wide blade

or the third prong are provided for your safety.

If the provided plug does not fit into your

outlet, consult an electrician for replacement

of the obsolete outlet.

10) Protect the power cord from being walked on

or pinched particularly at plugs, convenience

receptacles, and the point where they exit

from the apparatus.

11) Only use attachments/accessories specified by

the manufacturer.

12) Use only with the cart, stand, tripod, bracket,

or table specified by the manufacturer, or sold

with the apparatus. When a cart is used, use

caution when moving the cart/apparatus

combination to avoid injury from tip-over.

13) Unplug this apparatus during lightning storms

or when unused for long periods of time.

14) Refer all servicing to qualified service

personnel. Servicing is required when the

apparatus has been damaged in any way, such

as power-supply cord or plug is damaged,

liquid has been spilled or objects have fallen

into the apparatus, the apparatus has been

exposed to rain or moisture, does not operate

normally, or has been dropped.

For the state of california, USA only

Perchlorate Material –special handling may apply, see

www.dtsc.ca.gov/hazardouswaste/perchlorate

Perchlorate Material: Lithium battery contains

perchlorate

Precautions

 Play the unit on the power source specified in

“Specifications.”

 Since a strong magnet is used for the speaker,

keep personal credit cards using magnetic coding

or spring-wound watches away from the unit to

prevent possible damage from the magnet.

 Do not leave the unit in a location near a heat

source such as a radiator or airduct, or in a

place subject to direct sunlight, excessive dust,

mechanical vibration, or shock.

 Allow adequate air circulation to prevent internal

heat build-up. Do not place the unit on a surface

(a rug, a blanket, etc.) or near materials (a

curtain) which might block the ventilation holes.

 Should any solid object or liquid fall into the unit,

unplug the unit and have it checked by qualified

personnel before operating it any further.

 To clean the casing, use a soft cloth dampened

with a mild detergent solution.

 Never touch the wire of the external FM

antenna during a thunderstorm. Furthermore,

immediately disconnect the AC power cord

from the radio.

NOTES ON LITHIUM BATTERY
 Wipe the battery with a dry cloth to assure a

good contact.

 Be sure to observe the correct polarity when

installing the battery.

 Do not hold the battery with metallic tweezers,

otherwise a short-circuit may occur.

If you have any questions or problems concerning

your unit, please consult your nearest Sony dealer.

Features

 Clock Radio compatible with iPod®/iPhone®

 Wake or Sleep to iPod/Radio/Buzzer

 Easy to set A-B alarm

 2-5-7day alarm

 LCD Brightness control

 MEGA BASS

 MEGA Xpand

 Wireless Remote Commander

 No Power No Problem alarm system to keep

the clock and the alarm operating during a

power interruption with a CR2032 battery

installed

Specifications

AUDIO POWER SPECIFICATIONS

POWER OUTPUT AND TOTAL HARMONIC

DISTORTION:

With 6 ohm loads both channels driven, from

150 Hz -10,000 Hz; rated 3 watts per channel

minimum RMS power, with no more than 10 %

total harmonic distortion.
Time display

12-hour system
Section for iPod

DC out: 5V

MAX: 500mA
Radio section
Frequency range

Band Frequency

Channel step

FM

87.5 MHz – 108 MHz 0.1 MHz

AM

530 kHz – 1 710 kHz

10 kHz

General
Speaker

Approx. 5.7 cm (2

1

/

4

inches) dia. 6 Ω

Input

AUDIO IN jack (ø 3.5 mm stereo minijack)
Power output

3.5 W + 3.5 W (at 10% harmonic distortion)
Power requirements

120 V AC, 60 Hz

For clock back up: 3V DC, CR2032 battery (1)
Dimensions

Approx. 290.5 mm × 152.0 mm × 139.5 mm (w/h/d)

(11

3

/

8

inches × 5

15

/

16

inches × 5

1

/

2

inches)

including projecting parts and controls
Mass

Approx. 1.94 kg (4 lb 4 oz) including power

supply unit
Supplied accessories

Remote commander (1)

AM loop antenna (1)

Audio connecting cable (1)

Universal Dock Adapter for iPhone (1)

Universal Dock Adapter for iPhone 3G & iPhone

3GS (1)

Universal Dock Adapter for iPhone 4 (1)
Design and specifications are subject to change

without notice.

4-150-697-13(2)

This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset

to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product.

Connecting the

antenna

To connect the AM loop

antenna

The shape and the length of the antenna is

designed to receive AM signals. Do not dismantle

or roll up the antenna.

1

Remove only the loop part from the

plastic stand.

2

Set up the AM loop antenna.

3

Insert the AM antenna terminal into the

AM ANTENNA jack on the rear of the

unit.

To remove the AM loop

antenna

Pull the AM antenna terminal while pushing up

the terminal clamp.

Adjusting the AM loop antenna

Find a place and an orientation that provide good

reception.

 Do not place the AM loop antenna near the

unit or other AV equipment, as noise may

result.

Tip

Adjust the direction of the AM loop antenna for

best AM broadcast sound.

Preparing the remote

commander

Before using the card remote commander for the

first time, remove the insulation film.

To know when to replace the

battery

With normal use, the battery (CR2025) should

last for about six months. When the remote

commander no longer operates the unit, replace

the battery with a new one.

CR2025

Compatible iPod/iPhone

models

Compatible iPod/iPhone models are as follows.

Update your iPod/iPhone to use the latest software

before you use it.

iPod nano

3rd generation

(video)

iPod classic

iPod

4th generation

iPod touch

1st generation

iPhone 4

iPhone

iPod nano

1st generation

iPod

4th generation

(color display)

iPhone 3G

iPod nano

4th generation

(video)

iPod touch

2nd generation

iPod nano

2nd generation

(aluminum)

iPod

5th generation

(video)

iPod mini

iPod nano

5th generation

(video camera)

iPhone 3GS

iPod touch

3rd generation

Notes
 In these Operating Instructions, “iPod” is used

as a general reference to iPod functions on an

iPod or iPhone, unless otherwise specified by

the text or illustrations.

 The connector of the unit is for sole use with an

iPod. If you use devices that do not match with

the connector, connect to the AUDIO IN jack of

this unit with the supplied audio connecting

cable.

 Sony cannot accept responsibility in the event

that data recorded to an iPod is lost or damaged

when using an iPod connected to this unit.

Troubleshooting

Should any problem persist after you have made

the following checks, consult your nearest Sony

dealer.
The clock flashes “AM 12:00” due to a power

interruption.
 The battery is low. Replace the battery. Remove

the old battery and install a new one.

The radio, iPod or buzzer alarm does not

sound at the preset alarm time.
 Check that alarm “A” or alarm “B” is properly

displayed.

The radio or alarm of iPod is activated but no

sound comes on at the preset alarm time.
 Check the alarm volume setting.
There is no sound from the iPod.
 Make sure the iPod is securely connected.

 Adjust the VOLUME.
The iPod cannot be operated with this unit.
 Make sure the iPod is securely connected.
The iPod cannot be charged.
 Make sure the iPod is securely connected.
When Daylight Saving Time (summer time)

begins, the clock does not employ the

Daylight Saving Time automatically.
 Make sure the clock is set correctly.

 Press and hold CLOCK and SNOOZE/DATE/

SLEEP OFF simultaneously for at least

2 seconds to activate the Automatic DST

function.

Notes
 Do not attempt to charge the battery.

 If you are not going to use the remote

commander for a long time, remove the battery

to avoid any damage that may be caused by

leakage and corrosion.

About the backup

battery

To keep accurate time, this unit contains a

CR2032 battery as a backup power source.

The battery keeps the clock and the alarm

operating in the event of a power interruption.

To know when to replace the

battery

When the battery becomes weak, “” appears in

the display.

If a power interruption occurs while the battery is

weak, the current time and alarm will be erased.

Replace the battery with a Sony CR2032 lithium

battery. Use of another battery may cause a fire or

explosion.
Note

If “AM 12:00” flashes in the display when the unit

is connected to an AC outlet for the first time, the

battery may be weak. In this case, consult your

Sony dealer.

To replace the battery
1

Keep the AC plug connected to the AC

outlet, remove the screw that secures the

battery compartment lid at the bottom of

the unit using a screwdriver, and open

the lid (see Fig. ).

2

Insert a new battery in the battery

compartment with the  side facing up

(see Fig. ).

3

Close the battery compartment lid and

secure it with the screw (see Fig. ).

4

Press iPod & iPhone , RADIO

BAND, AUDIO IN or SNOOZE/DATE/

SLEEP OFF to turn “

” off in the

display.

Note

When you replace the battery, do not disconnect

the plug from the AC outlet. Otherwise, the

calendar, current time, alarm and station presets

will be erased.

Reset button

CR2032

If the time in the display is

incorrect after the battery is

changed (Reset)

Press the reset button with a pointed device. The

reset button is in the small hole located in the

battery compartment (see Fig. ).

©2009 Sony Corporation

Printed in China

FM/AM

Clock Radio

No Power No Problem is a trademark of Sony Corporation.

ICF-CS10iP

Operating Instructions

Dream Machine is a trademark of Sony Corporation.

Advertising
This manual is related to the following products: