Sony DPF-WA700 - Manual (Page 10)

Tabl
e of
C
o
n
tent
s
Let
’s
U
s
e
E
njo
y
ing
Mo
re
T
ro
u
b
les
hoo
ti
ng
In
dex
10 GB
To hang the photo frame on a wall (DPF-W700 only)
1
Prepare commercially available
screws suitable for the holes on the
rear of the unit.
2
Drive the commercially available
screws into the wall.
Make sure the screws protrude 2.5 mm to 3
mm (approx. 1/8 inch) from the surface of
the wall.
3
Hang the photo frame on the wall by fitting the screw head to the hole
on the rear of the unit.
• Use screws suited for the wall material. The screws may be damaged, depending on the type
of material used in the wall. Drive the screws into a stud in the wall or a pillar.
• Firmly tighten the screw so that the photo frame will not fall from the wall.
• When you want to re-insert a memory card, remove the photo frame from the wall then eject
and re-insert the memory card while the photo frame is placed on a stable surface.
• Remove the stand when you hang the photo frame on a wall.
• Connect the DC cable of the AC adaptor to the photo frame and hang the photo frame on the
wall. Then plug the AC adaptor into the wall outlet.
• Sony takes no responsibility for any accidents or damage caused by defects of attachment,
misuse, natural disasters, etc.
• While the photo frame is mounted on a wall, it may fall when you operate the buttons or the
touch screen. when operating the photo frame, support it carefully so as not to drop it.
4 mm ( 3 /
16
inch)
More than 25 mm (1 inch)
ø 5 mm ( 7 /
32
inch)
10 mm ( 13 /
32
inch)
Holes for hanging the unit
on the wall
2.5 mm - 3 mm
(approx.
1 /
8
inch)