Sony STR-DE495 - Manual (Page 40)

40
GB
1
Hold down the input selector button
whose input source you want to change
(for example, MD/TAPE).
2
Press the corresponding button of the
component you want to assign to the
input selector button (for example, 4 –
Tape deck).
The following buttons are assigned to select
the input source:
To operate Press
CD player 1
DAT deck 2
MD deck 3
Tape deck A 4
Tape deck B 5
LD player 6
VCR (command mode VTR 1*) 7
VCR (command mode VTR 2*) 8
VCR (command mode VTR 3*) 9
TV 0
DSS (Digital Satellite Receiver) >10
DVD ENTER
VCD player .
* Sony VCRs are operated with a VTR 1, 2 or 3
setting. These correspond to Beta, 8mm and
VHS respectively.
Now you can use the MD/TAPE button to
control the tape deck.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the input selector
buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
Remote Operations Function
Button
÷ TV Selects the channel entry
mode, either one or two
digit
TV/VIDEO TV Selects input signal: TV
input or video input.
TV VOL TV Adjusts the volume of the
+/– TV
TV CH TV Selects preset TV
+/– channels
Notes
• When you press the input selector buttons (VIDEO
1, VIDEO 2, DVD), the input mode of the TV
might not switch to the corresponding input mode
that you want. In this case, press the TV/VIDEO
button to switch the input mode of the TV.
• Some functions explained in this section may not
work depending on the model of the receiver.
• The above explanation is intended to serve as an
example only.
Therefore, depending on the component the above
operation may not be possible or may operate
differently than described.
• (STR-DE495 only) The MULTI CH function is not
available for set operation.
Changing the factory
setting of an input selector
button
If the factory settings of the input selector
buttons do not match your system components,
you can change them. For example, if you have
a tape deck and you do not have an MD deck,
you can assign the MD/TAPE button to your
tape deck.
Note that the settings of the TUNER button
cannot be changed.
Remote button description
(continued)