Sony SRS-T100PC - Manual

For the customers in the U.S.A.
INFORMATION
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
If you have any questions about this product, you may
call:
Sony Direct Response Center 1-(800)-222-7669
or write to:
Sony Direct Response Center 12451 Gateway Blvd.Fort
Myers, FL 33913
Declaration of Conformity
Trade Name:
SONY
Model No.: SRS-T100PC
Responsible Party: Sony Electronics Inc.
Address: 680 Kinderkamack Road,
Oradell, NJ 07649 USA
Telephone No.: 201-930-6972
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the
countries EEA (European Economic Area).
• Microsoft and Windows are registered trademarks of
Microsoft Corporation in the United States and/or
other countries.
• In this manual, Microsoft ® Windows ® XP Home
Edition and Microsoft ® Windows ® XP Professional are
referred to as Windows XP.
• In this manual, Microsoft ® Windows ® 2000 Professional
is referred to as Windows 2000.
• In this manual, Microsoft ® Windows ® Millennium
Edition is referred to as Windows Me.
• In this manual, Microsoft ® Windows ® 98 Second
Edition is referred to as Windows 98SE.
• All other names of systems and products are
trademarks or registered trademarks of their respective
owners ™ and
® marks are omitted in this manual.
© 2003 Sony Corporation Printed in Philippines
Active Speaker System
SRS-T100PC
3-246-388-11(1)
Operating Instructions
Manual de instrucciones
Features
Compact design
• A compact speaker system that you can easily carry
along with your laptop. With a USB connection to your
computer, a variety of sounds is available.
• With the power supply via the USB cable, the
connection of the AC power adaptor or batteries for
the speakers is not needed. (Note that when your
computer is running on batteries, the life span of the
battery is reduced).
• The USB cable can be stored within the speakers.
Simple settings
• By using the built-in rod, the distance between the
speakers can be freely extended and shortened.
• Requires a simple USB jack connection only.
• You can adjust the volume with volume control.
High quality sound
• The newly developed built-in class D, 1 bit digital
amplifier outputs clear digital sound with the least
noise from your computer.
• The newly developed 34mm Neodymium magnet
speaker provides a rich, balanced sound.
• The built-in MEGABASS circuit enhances bass sound,
irrespective of the playback volume levels.
Precautions
• After operating the system with the USB cable,
disconnect the USB cable from the computer if the
system is not to be used for an extended period.
• Do not open the cabinet. Refer servicing to qualified
personnel only.
• Do not leave the system in a location near heat sources,
or in a place subject to direct sunlight, excessive dust,
moisture, rain or mechanical shock.
• Should any solid object or liquid fall into the system,
remove the USB cable and have the system checked by
qualified personnel before operating it any further.
• Do not use alcohol, benzine, or thinner to clean the
cabinet.
• Although this system is magnetically shielded, do not
leave recorded tapes, watches, personal credit cards or
floppy disks using magnetic coding in front of the
system for an extended period.
If the TV picture or monitor display is
magnetically distorted
Although this system is magnetically shielded, there may
be cases that the picture on some TV sets/personal
computers sets may become magnetically distorted. In
such a case, turn off the power of the TV set/personal
computer set once, and after 15 to 30 minutes turn it on
again. For the personal computer set, take the
appropriate measures such as data storage before turning
it off.
When there seems to be no improvement Locate the
system farther away from the TV set/personal computer
set. Furthermore, be sure not to place objects in which
magnets are attached or used near the TV set/personal
computer set, such as audio racks, TV stands, toys etc.
These may cause magnetic distortion to the picture.
If you have any questions or problems concerning your
system that are not covered in this manual, please consult
your nearest Sony dealer.
Setting the stand
How to set the stand (see fig. A)
1 Slide the stand, pushing it in the
direction of the arrow
Note
If you set the stand without sliding it then it may be
damaged. Be very careful when you are setting the
stand.
2 Set the stand.
3 Pull out the stand until it is completely
set.
When storing the stand, perform the above
procedure in the reverse manner.
Tip
You can also set the stand as illustrated.
Preparations
Preparation 1: Connection (see fig. B)
1 Pull out the USB cable from the system
storage section.
2 Connect the USB connector (Type A
plug) of the system to the USB port of
your computer.
Notes on USB connection
•If your computer is connected to other USB
devices via a hub, there may be no sound or it
may be low. Connect the system to your computer
directly with the USB cable to avoid noise.
•If the USB cable is not properly connected, the
system may not be recognized on your computer.
Check the direction of the connector and connect
the USB cable properly.
stand
English
WARNING
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
To prevent fire, do not Cover the ventilation of the
apparatus with news papers, table-cloths, curtains, etc.
Do not place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects
filled with liquids, such as vases, on the apparatus.
Do not install the appliance in a confined space, such
as a bookcase or built-in cabinet.
CAUTION
You are cautioned that any changes or modification not
expressly approved in this manual could void your
authority to operate this equipment.
Owner’s Record
The model number and the serial number are located at
the rear of the unit.
Record the model number and the serial number in the
space provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.
Model No. SRS-T100PC
Serial No.
Left speaker Right speaker
Power indicator VOLUME
To increase the volume,
rotate in the direction of
the arrow; to decrease the
volume, rotate in the
opposite direction.
A
1 2 3
B
C
Type A plug
To the USB
type A jack of
a computer
1 2
Image
SRS-T100PC
Tested To Comply
With FCC
Standards
FOR HOME OR OFFICE USE