Sony HT-CT100 - Manual (Page 7)

7 US
Gettin
g
Sta
rted
Install an active subwoofer and a satellite
speaker as shown in the illustration below.
When you install the active subwoofer, allow for
a space of at least 30 cm (12 inches) on the active
subwoofer’s right side.
• Do not block the heat ventilation on the rear panel of
the active subwoofer.
To hang the satellite speaker
onto the TV stand
You can hang the satellite speaker onto the
following TV stand models (not supplied):
• SU-FL300M
• SU-FL300L
Use the speaker hook (supplied with the TV
stand) to hang the satellite speaker onto the TV
stand, in the same way as for SS-CT74. For
details, refer to the operating instructions
supplied with the TV stand.
To install the satellite speaker on
the wall
You can install the satellite speaker on the wall.
1
Prepare screws (not supplied) that are
suitable for the hook on the back of the
satellite speaker. See the illustrations
below.
2
Fasten the screws to the wall. The
screws should protrude 6 to 7 mm
(approx.
1 / 4 inches).
3
Hang the satellite speaker onto the
screws.
Align the hooks on the back of the satellite
speaker to the screws, then hang the satellite
speaker onto the two screws.
Installing the system
Note
HT-CASUAL
Satellite speaker
At least 30 cm
(12 inches)
Active subwoofer
Hook on the back of the satellite speaker
4 mm or 1 / 6 inches
more than 25 mm (1 inch)
5 mm
(
1 / 5 inches)
10 mm
(
2 / 5 inches)
265 mm
(10
2 / 5 inches)
6 to 7 mm
(approx.
1 / 4 inches)
continued