Sony CXS-GT5516F - Manual (Page 17)

17
Searching a track by listening
to track passages — ZAPPIN™
While playing back short track passages in a CD
or USB device in sequence, you can search for a
track you want to listen to.
ZAPPIN mode is suitable for searching for a
track in shuffle or shuffle repeat mode.
1
Press (ZAP) during playback.
After “ZAPPIN” appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
2
Press the select button or (ZAP) when
a track you want to listen is played
back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps 1 and 2.
Tips
• You can select the playback time from about 6
seconds/15 seconds/30 seconds (page 20). You
cannot select the passage of the track to playback.
• Press (SEEK) +/– or (1)/(2) (ALBUM –/+) in
ZAPPIN mode to skip a track or album.
• Pressing (BACK) also confirms a track to
playback.
Sound Settings and Setup Menu
Changing the sound settings
Adjusting the sound
characteristics
1
During reception/playback, press the
select button.
2
Rotate the control dial until the
desired menu item appears, then
press it.
3
Rotate the control dial to select the
setting, then press it.
The setting is complete.
4
Press (BACK).
The display returns to normal reception/play
mode.
The following items can be set (follow the page
reference for details):
The part of each track to
playback in ZAPPIN mode.
Track
(ZAP) pressed.
EQ7 PRESET (page 18)
EQ7 SETTING (page 18)
POSITION
SET POSITION (Listening Position setting)
(page 18)
ADJ POSITION*
1 (Listening Position
adjustment) (page 19)
SET SW POS*
1 * 2 (Subwoofer Position setting)
(page 18)
BALANCE
Adjusts the sound balance: “RIGHT-15” –
“CENTER” – “LEFT-15.”
FADER
Adjusts the relative level: “FRONT-15” –
“CENTER” – “REAR-15.”
DM+ (page 19)
RB ENH (Rear Bass Enhancer) (page 19)
SW LEVEL* 2 (Subwoofer Level)
Adjusts the subwoofer volume level: “+10 dB”
– “0 dB” – “–10 dB.”
(“ATT” is displayed at the lowest setting.)
AUX VOL* 3 (AUX Volume level)
Adjusts the volume level for each connected
auxiliary equipment: “+18 dB” – “0 dB” – “–8
dB.”
This setting negates the need to adjust the
volume level between sources.
*1 Hidden when “SET POSITION” is set to “OFF.”
*2 When the audio output is set to “SUB-OUT”
(page 20).
*3 When AUX source is activated (page 21).