Sony KDL-70XBR3 - Manual (Page 16)

Getting Started
16
Installing the TV
Preventing the TV
from Toppling Over 1 Attaching the Support Belt.
1 Screw the support belt (supplied) to the TV stand with a wood screw
(supplied).
2 Attach the support belt to the stand with the securing screw (supplied)
using a coin, etc.
3 Adjust the length by pulling the support belt toward you while holding
the TV stand.
2 Securing the TV to the wall with cords.
1 Thread strong cords or chains (not supplied) through the handle on the
rear side of the TV, and tie firmly.
2 Secure the cords or chains to a stable place, such as a wall or column.
✍
Be sure to take measures to prevent the TV from toppling over and
causing injury.
✍
The supplied wood screw may not be used depending on the type of TV
stand. In this case, or when the securing strength is not enough, use
commercial screws 1/8 to 3/16 inches (3 to 4 mm) diameter to fit to the
TV stand. Consult your dealer about the types of screw.
2
3
1
2
1
Tie
firmly