Sony PFM-32C1 - Manual (Page 96)

44
(GB)
Controlling Power On/Off Automatically (Timer Function)
7
Press M/m to select the timer mode.
Off: Power turned off at the time set with Off
Time.
On: Power turned on at the time set with On
Time.
On/Off: Power turned on at the time set with On
Time, and turned off at the time set with Off
Time.
8
Press ENTER.
The menu returns to the On/Off Timer menu.
9
Press M/m to move the cursor (yellow) to “On
Time” and press ENTER.
The following menu appears on the display panel.
The area behind the hour is displayed in light blue.
T i m e r / C l o c k
O n / O f f T i m e r : O n
R e p e a t : O f f
T i m e r M o d e : O n / O f f
O n T i m e : 0 0 : 0 0
O f f T i m e : 0 0 : 0 0
10
Press M/m to set the hour and press ENTER.
The time is entered and the area behind the
minutes is displayed in relief.
11
Press M/m to set the minute and press ENTER.
Press < to return to the screen shown in step 2 .
When using the buttons on the unit, press the MENU
button to close the menu, and set [MENU Function]
(page 21 (GB)) on the Initial Setup menu to [Return].
The MENU button on the unit then has the same
function as the
< button.
12
Press M/m to move the cursor (yellow) to “Off
Time” and press Enter. Do the same thing for the
power on hour and minute.
Power Saving Function
1
In the Timer/Clock menu, press M/m to move the
cursor (yellow) to “Auto Shutoff” and press
ENTER.
The following menu appears on the display panel.
T i m e r / C l o c k
S l e e p : O f f
C l o c k S e t
C l o c k D i s p l a y : O f f
O n / O f f T i m e r : O f f
A u t o S h u t o f f :
, t o s e l e c t , p r e s s
t o r e t u r n
ENTER
O f f
5 m i n
1 0 m i n
2
Press M/m to select the length of time until the
change to power saving mode.
Off: The power saving function does not work.
5min: Changes to the power saving mode after
five minutes if there is no input signal.
10min: Changes to the power saving mode after
10 minutes if there is no input signal.
When the power saving mode is on, the unit
changes to standby mode.
To cancel the power saving function
• Press the 1 switch on the 1 (standby) switch /
indicator section or the POWER ON switch on the
Remote Commander.