Sony CDX-M20 - Manual (Page 6)

6
Getting Started
Switching the FM/AM
tuning step
The FM/AM tuning step is factory-set to the
200 kHz (FM)/10 kHz (AM) position. If the
frequency allocation system of your country
is based on 50 kHz (FM)/9 kHz (AM) or 100
kHz (FM)/10 kHz (AM) step, set the tuning
step before use.
This setting appears when turned off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until “TUNER-
STP” appears, then press it.
3
Rotate the control dial to select from
“50K/9K,” “100K/10K” or “200K/10K,”
then press it.
Receivable frequency by selected frequency
setup:
FM 50 kHz: 87.50 MHz, 87.55 MHz, 87.60
MHz...
FM 100 kHz: 87.5 MHz, 87.6 MHz, 87.7
MHz...
FM 200 kHz: 87.5 MHz, 87.7 MHz, 87.9
MHz...
AM 9 kHz: 531 kHz, 540 kHz, 549 kHz...
AM 10 kHz: 530 kHz, 540 kHz, 550 kHz...
Canceling the DEMO
mode
You can cancel the demonstration display
which appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until “DEMO”
appears, then press it.
3
Rotate the control dial to select
“DEMO-OFF,” then press it.
The setting is complete.
4
Press (BACK).
Setting the clock
The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until “CLOCK-
ADJ” appears, then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press

–/+.
4
After setting the minute, press the
select button.
The setup is complete and the clock
starts.
To display the clock, press

.