Sony MHC-BX5 - Manual (Page 9)

9
To tune in a station with a weak
signal
Press + or – (TUNING +/– on the remote)
repeatedly to tune in the station manually.
To set another station to the
existing preset number
Start over from step 1. After step 3, turn
SHUTTLE until it clicks to select the preset
number you want to store the other station.
You can add a new preset number after the
last preset number.
To erase the preset station
1 Hold down TUNER MEMORY until a
preset number appears in the display.
2 Turn SHUTTLE until it clicks to select the
preset number you want to erase.
Select “ALL ERASE” when you want to
erase all the preset stations.
3 Press ENTER .
“COMPLETE” appears.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change the AM tuning interval
(Except for the European and Middle
Eastern models)
The AM tuning interval is factory set to 9 kHz (10
kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down the ENTER button,
turn the power back on. When you change the
interval, AM preset stations will be erased. To reset
the interval, repeat the same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Saving the power in
standby mode
(For European and North
American models only)
You can lower the power consumption to
minimum (Power Saving Mode) and save
energy in standby mode.
,
Press DISPLAY repeatedly when the
power is off. Every time you press
the button, the system switches as
follows:
t Demonstration t Clock
Power Saving Mode T
The system is turned on/off by pressing
?/1
.
Tips
• ?/1 indicator and timer indicator (when the timer
is set) light up even in the Power Saving Mode.
• The timer works in the Power Saving Mode.
Note
You cannot set the time in the Power Saving Mode.
To cancel the Power Saving Mode
Press DISPLAY once to show the
demonstration, twice to show the clock
display.
DISPLAY
?/1
(Power)