Sony MHC-BX2 - Manual (Page 33)

33
Connecting audio
components
Select one of the following connections,
depending on the component to be connected
and method of connecting. Refer to the
instructions of each component.
Connecting an MD deck
for digital recording
You can record from CD into the MD deck
digitally by connecting an optional optical
cable.
4
Set the time to start recording.
Press . or > repeatedly to set the
hour, then press ENTER.
The minute indication starts flashing.
Press . or > repeatedly to set the
minute, then press ENTER.
The hour indication flashes again.
5
Set the time to stop recording
following the above procedure.
The start time, followed by the stop time,
the preset radio station to be recorded
(e.g., “TUNER FM 5”) appear, then the
original display appears.
6
Insert a recordable tape.
7
Turn off the power.
When the recording starts, the volume
level is set to the minimum.
To check the setting
Press CLOCK/TIMER SELECT and press
.
or > repeatedly to select “REC”, then
press ENTER.
To change the setting, start over from step 1.
To cancel the timer operation
Press CLOCK/TIMER SELECT and press
.
or > repeatedly to select “TIMER
OFF”, then press ENTER.
Notes
• If the power is on at the preset time, the recording
will not be made.
• You cannot set the timer if the starting time and
stopping time are the same.
• When you use the Sleep Timer, Timer-recording
will not turn on the system until the Sleep Timer
turns it off.
• You cannot activate Timer-recording and Daily
Timer at the same time.
To the digital input jack of the MD deck
Optional components
continued
1 2 REC SLEEP
VOLUME
ALL DISCS
Я