Sony ICD-SX700D - Manual (Page 16)

ICD-SX700 4-127-576-11(1)
1
GB
Disconnecting the IC
recorder from your
computer
Follow the procedures below; otherwise,
data may be damaged.
1
Make sure that the operation
indicator is not flashing.
2
Disconnect the USB connecting
cable connected to the IC recorder
from the USB connector of the
computer.
On the Windows screen, left-click
“Safely Remove Hardware” on the
taskbar, and click “Safely remove USB
Mass Storage Device.”
On the Macintosh screen, drag the “IC
RECORDER” on the desktop to “Trash”
and drop it there.
For details on disconnecting the
IC recorder, refer to the operating
instructions supplied with your
computer.
Tips
You can charge the rechargeable batteries
by connecting the IC recorder to an AC
outlet using a USB AC adaptor (not supplied)
(page 124).
When replacing the batteries, messages
recorded or alarm settings are not erased
even when you remove the batteries.
When replacing the batteries, the clock
continues moving for a certain period of
time after you remove the batteries.
Notes
While “ ” or “ ” is flashing instead
of the battery indicator, you cannot charge
the batteries. Charge the batteries in an
environment with a temperature of 5 °C
- 35 °C (41 °F - 95 °F).
If “USB CHARGE” in the “DETAIL MENU”
menu is set to “OFF,” you cannot charge the
batteries using your computer. Set “USB
CHARGE” to “ON” (page 91).
During playback using the internal speaker,
you cannot charge the batteries.
When you use the IC recorder with
rechargeable batteries, the battery indicator
may not light fully.








