Sony STR-DE875 - Manual (Page 69)

69
Additional Information
5-15 cm
Setting remote control codes that are not stored
in the remote
When a remote control code is not one of the presets
stored in the remote, it is possible for the remote to learn
the code using the Learning function.
1
Press SLEEP while pressing down USE MODE.
The indicator lights.
2
Press the function button for the component you
want to learn functions for.
For example, if you are going to learn an operation for
a CD player, press CD.
3
Press the button you want to use for the Learning
function.
The indicator turns off while a valid button is pressed,
then blinks slowly.
4
Point the remote control code receiver section of
the remote toward the receiver/transmitter on the
remote control to be learned.
5 Press the appropriate button on the remote control
to be learned to send the remote button code.
Lightly pressing the button once should be sufficient.
If learning is completed successfully, the indicator
slowly flashes twice and the remote automatically
exits the learning mode.
When learning is not completed successfully, the
indicator flashes 4 times in quick succession and the
procedure returns to step 5.
If the memory of the remote is already full, the
indicator flashes 8 times in quick succession and the
remote automatically exits the learning mode.
Notes
• You can program up to 80 buttons for the Learning function. In
some cases, you may not be able to program even if you have
not programmed 80 buttons.
• In steps 2 and 3, the indicator turns off while a valid button is
pressed.
• In step 3, if several buttons that can be used for learning are
pressed, only the last pressed button is valid.
• In step 5, if a button that can be used for learning is pressed, the
new button is selected and the learning procedure returns to
the beginning of step 5.
• You can use TV/VIDEO only for the MONITOR function.
z To activate the function after programming.
Press the programmed button to activate the function you want.
To cancel learning
Press USE MODE during any step. The remote
automatically exits the learning mode.
To clear the learned codes
Start over from step 1. After step 3, press SLEEP for more
than 2 seconds. The indicator lights twice slowly and the
learned code is cleared. If SLEEP is pressed less than 2
seconds, the learning procedure returns to the beginning
of step 5.
When a learned code is cleared, if the button was
previously programmed for another function, the
programmed code for that button can be used.
To clear the memory of the remote
To clear all programmed and learned signals, do the
following to reset the remote to factory settings.
At the same time, press ?/1, AV ?/1, and MASTER
VOLUME.
The indicator flashes 3 times, then goes off.
To use a command that has been learned
When selecting a learned function, press the learned
button for that function.
.
M
m nN
X
> x