Sony SAT-T60 - Manual (Page 102)

8'

   5

!  

 This setting is off by default. When    5

! 
 

 is on, the Receiver can determine whether the phone line is in use by
detecting voltage on the line. This allows it to avoid disrupting a call in progress (such
as another modem call).
However, if you are experiencing “Failed, Line unavailable” errors, or if the Receiver
is not making daily calls, you may have a low-voltage phone system that the Receiver
cannot detect. In this case, try selecting “Off” for
 5

!  

.
With  5

!  

 turned off, the Receiver must pick up the line to check
for a dial tone. If you are on the phone when the Receiver tries to call, you may hear a
click on the line. If you have another modem call in progress (on your computer or
other device), that call may be disrupted if the Receiver attempts to make a service
call.
If you turn off  5

!  

 and you have a standard dial-tone, turn on


! 

 (described next).
 

! 

 This setting is on by default. If you leave it on, the Receiver
will check for a dial tone before it starts dialing. However, if you have a non-standard
dial tone (for example, an analog PBX system), or a stuttering dial tone (as some voice
messaging systems have), the Receiver will be unable to detect the dial tone and will
not make its daily call.
  

3 After changing  

!
$:
 , you should
select
  

3. The Receiver will make a short phone call with
the new settings. If the test is successful, press SELECT to continue. If the test is not
successful, you may have to change some phone dialing options; see “Phone
Troubleshooting,” described on page 92.
D , 
 ,      +3  
,    
   
'     ( 3 
 
      
    
3 
  +*  
  +* 

 
%'*
        4      
   
SONY COMBO 2 VG.book Page 91 Friday, December 1, 2000 12:05 PM