Sony DSC-R1 - Manual (Page 61)

61
E
n
joy
in
g
the c
a
me
ra
Monitor mode setting
When you shoot under fluorescent light, flicker may occur on the screen depending on
regions. You can reduce that flicker.
Set the MONITOR switch to the desired mode.
When the flicker is not reduced in [FRAMING] mode
Normally, the camera automatically detects the flickering cycle and reduces the flicker.
However, if it is not detected properly, set the power supply frequency (50Hz/60Hz) of your
region beforehand. The flicker will be reduced.
1 Display the (Setup) screen (page 32).
2 Select (Camera 2) by moving the multi-selector to v/V, [Flicker Reduction] by moving to
B/v/V.
3 Select the desired mode by moving to B/v/V, then press the center of the multi-selector.
( : The default setting)
Reducing flicker P S A M
FRAMING Reduces the flicker.
To confirm the subject, the screen is brighter while monitoring
(Auto Bright Monitoring).
PREVIEW Does not reduce the flicker.
Before shooting, you can confirm the depth of field (page 38).
Starting time and shutter lag time are shorter than that of
[FRAMING] mode.
60Hz For regions where the power supply frequency is 60 Hz.
50Hz For regions where the power supply frequency is 50 Hz.
Auto The camera automatically detects the power supply
frequency: 50 Hz or 60 Hz.
MONITOR
FRAMING PREVIEW
Multi-selector
MENU button
MONITOR switch
2