Sony WX-4500X - Manual (Page 21)

21
Adjusting the equalizer curve
You can store and adjust the equalizer settings
for frequency and level.
1
Press (SOURCE) to select a source
(radio, CD, MD, or tape).
2
Press (MENU) , then rotate the jog
roller until “EQ Tune” appears.
3
Push the jog roller.
4
Press (SEEK/AMS -) or (SEEK/AMS +) to
select the desired equalizer curve,
then push the jog roller.
Each time you press (SEEK/AMS), the item
changes.
5
Select the desired frequency and level.
1 Press (SEEK/AMS -) or (SEEK/AMS +)
to select the desired frequency.
Each time you press (SEEK/AMS), the
frequency changes.
62 Hz y 157 Hz y 396 Hz y 1.0 kHz
y 2.5 kHz y 6.3 kHz y 16 kHz
2 Rotate the jog roller to adjust the
desired level.
The level is adjustable by 1 dB steps from
–10 dB to +10 dB.
To restore the factory-set equalizer curve,
push the jog roller for 2 seconds.
6
Push the jog roller.
When the effect setting is complete, the
normal playback mode appears.
Adjusting the front and rear
volume
1
During playback or radio reception,
press
(SOUND) repeatedly until “FAD”
appears.
2
Press (SEEK/AMS -) or (SEEK/AMS +) to
adjust the volume of front/rear
speakers.
After 3 seconds, the display returns to normal
playback mode.
Adjusting the cut-off frequency for the
front/rear speakers
To match the characteristics of the installed
speaker system, you can select the cut-off
frequency of the speakers.
1
During playback or radio reception,
press
(MENU) .
2
Rotate the jog roller until “HPF”
appears.
3
Press (SEEK/AMS -) or (SEEK/AMS +) to
select the cut-off frequency.
Each time you press (SEEK/AMS), the
frequency changes as follows:
off (default setting) y 78 Hz y 125 Hz
4
Push the jog roller.
After the frequency setting is complete, the
display returns to normal playback mode.
Cut-off frequency
Frequency (Hz)
Le
ve
l
off