AT&T 272 - Manual (Page 6)

4
Table/Desk Installation
Follow Steps 1 and 2 above.
3 Connect the long line cord(s) to the telephone.
•
If you have a two-line wall jack, use only the line cord with
the clear modular plugs on each end. Plug one end into the jack
labeled
L1 OR L1/L2 on the bottom of the telephone. Thread
the line cord through the groove on the bottom of the telephone
so the set will lie flat on your table.
• If you have two separate wall jacks, use both line cords.
Insert one end of the cord with blue plugs into the jack labeled
L1 OR L1/L2 on the bottom of the telephone. Insert one end of
the cord with clear plugs into the jack labeled
L2 on the bottom
of the telephone. Thread the line cords through the groove on
the bottom of the telephone so the set will lie flat on your table.
INSTALLATION
Thread line cord
through groove
so set lies flat
on table
4 Connect the line cord(s) to your modular wall jack(s).
•
If you have a two-line jack, plug the free end of the line cord
into the modular jack. Make sure the cord snaps firmly into
place.
• If you have two separate jacks, plug the free end of the cord
with blue plugs into the modular jack for Line 1. Plug the free
end of the cord with clear plugs into the modular jack for Line 2.
L2 jack
L1 or L1/L2
jack