AT&T 272 - Manual (Page 7)

5
5 Connect the handset to the telephone.
Plug the coiled cord into the handset jack on the side of the phone.
Plug the other end of the coiled cord into the handset.
6 Check for dial tone.
Lift the handset, press
L on the base, and listen for a dial tone.
Then press l on the base. If you do not hear a dial tone, turn to
IN CASE OF DIFFICULTY.
7 Confirm Lines 1 and 2.
To determine which line is which, press
L on the base and call
one of your telephone numbers. If you hear a busy signal, Line 1 is the
number you called. If Line 2 rings, it is the number you called.
Wall Installation
INSTALLATION
Thread line cord
through groove
so set lies flat
Follow Steps 1 and 2 above.
3 Connect line cord(s) to telephone.
•
If you have a two-line wall jack, use only the short line cord.
Plug one end into the jack labeled
L1 OR L1/L2 on the bottom
of the telephone. Thread the line cord through the groove on
the bottom of the telephone.
• If you have two separate wall jacks, use the short line cord
and one of the long cords. Plug one end of the short line cord
into the jack labeled
L1 OR L1/L2 on the bottom of the
telephone. Plug one end of the long line cord in the jack labeled
L2 on the bottom of the telephone. Thread the line cords
through the groove on the bottom of the telephone.
L2 jack
L1 or L1/L2
jack