Sony SDM-N50R - Manual (Page 8)

8
G:\_Upload\4086226111\4086226111SDMN50RUC\02GB-SDMN50RUC\01GB02BAS-UC.fm masterpage:Left
SDM-N50R
4-086-226-11 (1)
Setup
Before using your monitor, check that the following items are
included in your carton:
• LCD display
• Media engine
• Media engine stand
• Power cord
• System connecting cable (2 m)
(applicable cable type: DP-2)
• HD15 (RGB) video signal cable
• Audio cord (stereo miniplug)
• Windows Monitor Information Disk/Utility Disk
• Macintosh Utility Disk
• Warranty card
• This instruction manual
Step 1: Connect the media engine
to your computer
Turn off the media engine and computer before connecting.
Note
Do not touch the pins of the video signal cable connector as this might
bend the pins.
x Connecting to an IBM PC/AT or compatible
computer
x Connecting to a Macintosh
When connecting this monitor to a Macintosh computer, use the
Macintosh adapter if necessary. Connect the Macintosh adapter to the
computer before connecting the cable.
Step 2: Connect the display and
media engine
Turn off the display and media engine before connecting.
Caution
Be sure to install the media engine vertically as shown above. Installing
the media engine lying flat may block ventilation, and may cause a
malfunction.
Note
Grasp the plug when connecting the cable.
to INPUT1 or
INPUT2 connector
HD15 (RGB) video
signal cable (supplied)
to video output
IBM PC/AT or
compatible computer IBM PC/AT or
compatible computer
to INPUT1 or
INPUT2 connector
HD15 (RGB) video
signal cable (supplied)
to video output
Macintosh
to SYSTEM
CONNECTOR
of the media
engine
system connecting
cable (2 m) (supplied)
to SYSTEM
CONNECTOR
of the display
01GB02BAS-UC.book Page 8 Friday, August 17, 2001 10:40 AM