AEG BP5003021 - Manual (Page 27)

To change length of selected procedure (P1 or P2), press to set , then press or
to set length for the pyrolytic procedure.
You can use the End function to delay start of the cleaning process.
When the oven reaches pre-set temperature, the door locks. The symbol and the bars of
the heat indicator come up, until the door unlocks again.
During pyrolytic cleaning the lamp is off.
Cleaning reminder
To remind you that the pyrolytic cleaning is necessary the cleaning reminder symbol flashes
in the display PYR after every activating and deactivating the appliance for the next 10 sec-
onds.
The cleaning reminder goes off the display:
• after end of the pyrolytic cleaning function;
• if you use or , when is flashing;
Shelf support
You can remove the shelf support to clean the side walls.
Removing the shelf support
1.
Pull the front of the shelf support away
from the side wall.
2. Pull the shelf support from the back of
the side wall to remove it.
To install the shelf support follow the proce-
dure in reverse.
Valid with telescopic runners:
The retaining pins on the telescopic shelf
runners must point to the front!
Oven lamp
WARNING!
There is a risk of electrical shock.
The oven lamp and the lamp glass cover can be hot.
1
2
Care and cleaning 27