Sony DMX-DVD - Manual (Page 15)

15
Attaching the Mounting Bracket to the TV
1
With the bracket fully extended, insert the guide
pins on the bracket into the guide holes on the TV.
The holes on the bracket should align to the holes on
the TV.
2
Insert the 2 plastic fasteners (supplied) into the
holes, then press in the head of the fasteners until
they click.
~
Do not push on the head of the plastic fastener until you
have inserted it into the hole on the TV.
3
Slide the bracket so that the viewing window covers
the corresponding number (see the illustrations and
table on the previous page). If the viewing window
indicates Bracket Setting 2, be sure to use a Velcro
strip (supplied); see previous page.
4
Align the slider on the bottom of the receiver unit
with the groove of the installation bracket.
5
Slide down the DVD player onto the bracket with
the DVD slot facing the outer edge of the TV. Before
proceeding to the next step, make sure that you are
satisfied with the position of the DVD player in
relation to the TV.
6
Secure the location of the sliding bracket by
screwing the Thumb Screw into the screw point
located just beneath the viewing window. If Bracket
Setting 2 is used, peel off the arrow label by pulling
downwards, and firmly press the bracket onto the
TV.
PULL
1 2
Plastic Fasteners
Arrow Label
1
2
1 2
Thumb Screw
PULL
1 2
1 2
PULL