Sony DCR-PC101 - Manual (Page 105)

105
Editing
Audio dubbing
Monitoring the new recorded sound
(1) Play back the tape on which you added audio.
(2) Select AUDIO MIX in
in the menu settings, then press EXEC (p. 187).
(3) Press r/R to adjust the balance between the original sound (ST1) and the new
sound (ST2), then press EXEC.
About five minutes after you disconnect the power source or remove the battery pack,
the setting of AUDIO MIX returns to the original sound (ST1) only. The default setting
is original sound only.
Notes
•New sound cannot be recorded on a tape already recorded in the 16-bit mode (32 kHz,
44.1 kHz or 48 kHz) (p. 190).
•New sound cannot be recorded on a tape already recorded in the LP mode.
•You cannot add audio with the DV Interface.
•New sound cannot be recorded on blank portions of the tape.
If the i.LINK cable (optional) is connected to your camcorder
You cannot add new sound to a recorded tape.
We recommend that you add new sound on a tape recorded with your camcorder
If you add new sound on a tape recorded with another camcorder (including other
DCR-PC101), the sound quality may become worse.
If you set the write-protect tab of the tape to lock
You cannot record on a tape. Slide the write-protect tab to release the write protection.
VCR SET
H i F i SOUND
AUD I O M I X
A/V
c DV OUTST1 ST2
EXIT
RET. EXEC R r