Sony EBS-SP10 - Manual (Page 18)

SP-TUNE User Manual
17
10 Specifications
10.1 Power source
12v 15 Watt DC wall supply
5.65 Watts Maximum with 12v DC input
10.2 Applicable signals
Color system: NTSC (RF and AV inputs)
Scanning format: 525i (480i), 525p (480p)
Receiving RF signals – US Standard Air, US Standard Cable, Cable HRC, Cable IRC
Supported audio standards: auto-detection, BTSC-STEREO, BTSC-MONO+SAP
Serial port – RS-232C compatible, can be used for Plasma Display control, firmware update, and
SP-TUNE control/diagnostics. Baud rate – 9600 (for Display control) or 115200 (for other
purposes). 8 bits data, 1 start bit, 1stop bit, no parity bit.
10.3 Connection terminals
Video IN (RCA)
S-Video IN (Mini DIN 4pin)
Component YPbPr/RGB+HV IN – 15-pin female VGA-compatible connector.
Audio stereo IN/OUT – 8 pin mini DIN. Requires adapter cable with 4 pairs of RCA connectors.
ANT (aerial) IN – RF UHF/VHF
Sony Service Port – RJ11
Component YPbPr/RGB+HV OUTPUT – 15-pin female VGA-compatible connector.
IR IN – 3.5mm TRS (Tip – Signal, Ring – 12v (if jumped internally), Sleeve – Ground)
IR OUT – 3.5mm TRS (Tip – Signal, Ring – NA, Sleeve – Ground)
RS-232 – DB9 Connector (2- RX, 3- TX, 5- Ground)
Logic IN – 3.5mm TRS (Tip – Input Signal, Ring – NA, Sleeve – Ground)
8 Pin Mini-DIN Audio connector pinout:
1 – SVideo audio Right IN
2 – YPbPr audio Left IN
3 – Composite audio Right IN
4 – SVideo audio Left IN
5 – Right Line OUT