Controlling your tv or av amplifier (receiver), With the supplied remote, Controlling tvs with the remote – Sony DVP-NS999ES User Manual
Page 72
72
Controlling Your TV or AV
Amplifier (Receiver) With
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
If you connect the player to an AV amplifier
(receiver), you can control the volume with
the supplied remote.
Notes
• Depending on the connected unit, you may not be
able to correctly control your TV or AV amplifier
(receiver) using some of the buttons below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number you have set may be reset to the
default setting. Set the appropriate code number
again.
Controlling TVs with the remote
1
Slide the TV/DVD switch to TV.
2
While holding down [/1, press down
on the scroll key.
“TV P-1” (default) appears in the LCD
screen.
3
Release [/1.
4
Toggle the scroll key up or down to
select your TV’s manufacturer code
(see “Code numbers of controllable
TVs” below).
5
Press down on the scroll key.
The manufacturer code flashes and the
remote is set.
When the TV/DVD switch is set to TV,
the remote performs the following:
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
[
/1
VOL +/–
WIDE
MODE
TV/VIDEO
Number
buttons
TV/DVD
switch
Scroll key
CH +/–
ENTER
[/1
Turns the TV on or off
VOL +/–
Adjusts the volume of the TV
WIDE MODE
Switches to or from the wide
mode of a Sony wide TV
TV/VIDEO
Switches the TV’s input
source between the TV and
other input sources
CH +/–, number
buttons and
ENTER
Selects the channel of the TV
Manufacturer
Code number
Sony (default)
1
Akai
4
AOC
4
Centurion
12
Coronado
3
Curtis-Mathes
12
Daytron
12
Emerson
3,4,14
Fisher
11
General Electric
6,10
Gold Star
3,4,17
Hitachi
2,3
J.C.Penney
4,12
JVC
9
KMC
3
Magnavox
3,8,12
Marantz
4,13