Sony KDX-46Q005 - Manual (Page 44)

Setting Up the TV
42
KDX-46Q005
2-592-150-12(2)
Satellite Receiver
with a VCR and
Cable Disconnect all power sources before making any connections.
1
Connect the CATV cable to the single (input) jack of the splitter.
2
Using a coaxial cable, connect one of the splitter’s two output jacks to
the TV’s CABLE jack.
3
Using a coaxial cable, connect the splitter’s other output jack to the
VCR’s VHF/UHF IN jack.
4
Connect the satellite antenna cable to the satellite receiver’s
SATELLITE IN jack.
5
Using A/V and S VIDEO cables, connect the satellite receiver’s AUDIO
and S VIDEO OUT jacks to the VCR’s AUDIO and S VIDEO IN jacks.
6
Using A/V and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
7
Run Initial Setup, as described in “Setting Up the TV Channel List” on
page 59.
✍
If your VCR or satellite receiver is not equipped with S VIDEO, use a
VIDEO cable (yellow) instead of the S VIDEO cable.