Sony PFM-500A2WU - Manual (Page 23)

23
(EN)
2
Press >/. to move the cursor (z) to “CONFIG”
and press ENT.
The CONFIG menu appears on the monitor screen.
3
Press >/. to move the cursor (z) to “DISPLAY”
and press ENT.
The following menu appears on the monitor
screen.
4
Press > to set “DISPLAY” to OFF and press ENT.
The DISPLAY function is disabled.
To activate the information function, set “DISPLAY”
to ON at the step
4 above.
Note
You can display the input signal information anytime
by pressing the DISPLAY button on the Remote
Commander, regardless of the above setting.
The input signal information list
Color system or horizontal/vertical frequency
Signal
type
Input signal Color system or horizontal/vertical
frequency display
NTSC NTSC
PAL PAL
VGA a) (Graphics) 31.5 kHz 60 Hz
VGA (Text) 31.5 kHz 70 Hz
HDTV 33.8 kHz 60 Hz
Mac b) 13" 35.0 kHz 67 Hz
VESA c) 800
×
600 37.9 kHz 60 Hz
VESA 1024
×
768 48.4 kHz 60 Hz
Mac 16" 49.7 kHz 75 Hz
ATI d) 1280
×
1024 64.0 kHz 60 Hz
Mac 21" 68.7 kHz 75 Hz
VESA 1280
×
1024 80.0 kHz 75 Hz
a) VGA is a registered trademark of the International
Business Machines Corporation, USA.
b) Mac (Macintosh) is a registered trademark of Apple
Computer, Inc.
c) VESA is a registered trademark of Video Electronics
Standard Association.
d) ATI is a registered trademark of ATI Technologies, Inc.
Note
When inputting the HDTV signal, input the tri-level
sync signal to the G/Y IN connector.
C O N F I G
E N H A N C E : H I G H
H F I L T E R : A U T O
D I S P L A Y : O N
P O W E R S A V E : 5 m
L A N G U A G E
S E L E C T C A N C E L ENTER MENU
D I S P L A Y : O N
Actual on-screen display of the monitor status
On-screen display Significance
31.5kHz / 60Hz (eg.) The selected input signal is
computer RGB.
525 / 60 (eg.) The selected input signal is RGB or
component video.
NTSC The selected input signal is NTSC.
PAL The selected input signal is PAL.
OTHERS The input signal is out of the capture
range.
NO SYNC There is no input signal.
MUTING The sound is muted.
RGB1 RGB The signal mode of RGB1 is set to
RGB.
RGB1 YUV The signal mode of RGB1 is set to
component video.
LINE COMP Composite video input is selected at
LINE.
LINE Y/C Y/C video input is selected at LINE.
STILL The picture is frozen.
3 1 . 5 kHz / 6 0 Hz
R G B 1 · R G B
Note
If computer signals more than 100kHz are input and if
the monitor can receive the signals, the screen display
(horizontal frequency) will be fixed at 99.9kHz.