Sony HAR-D1000 - Manual (Page 10)

10
Connections
Connecting your personal computer with the HAR-D1000
Use a USB cable to connect your personal computer with the HAR-D1000.
?
?
Notes
• Be sure to install this software before connecting the HAR-D1000 to your
computer. If not, this software may not function properly.
• Be sure to log on through the administrator’s account to install a software.
(for Windows2000)
• Make sure each plug is straight when you insert it. Inserting it at an angle
may damage the connector parts.
• Connect the USB connector directly to the computer's USB port with a USB
cable. If you connect the two units via a USB hub, the computer may not be
able to control the connected HAR-D1000.
• In case of Windows2000/WindowsMe, if you turn off the HAR-D1000 with a
USB cable connected, a warning message may appear in the display.
• Some HAR-D1000 functions are not supported by M-crew for HAR-D1000
(e.g., Synchro-Recording from a CD changer, etc.). If Synchro-Recording from
a CD changer is started on the HAR-D1000 while “M-crew for HAR-D1000”
software is starting up, the software is automatically ended.
• A single HAR-D1000 should be operated by a single computer loaded with
the “M-crew for HAR-D1000” software.
If you use the same HAR-D1000 with no more than one computer in which
the software has been installed, HAR-D1000 data may not be properly read in.
If this occurs, click the Reload button (refer to the Help).
HAR-D1000
Computer
To the USB connector
To the
computer’s
USB port
USB cable
With the plug
correctly oriented,
insert it fully into the
connector.
Make sure to connect the
HAR-D1000 directly to your
computer. Do not connect
via a USB hub.