Sony DAV-X1V - Manual (Page 33)

33 US
B
a
si
c
Op
er
a
tio
ns
Selecting the connected
component
You can use a VCR or other components
connected to the VIDEO 1 or 2 jacks on the rear
panel. Refer to the operation manual supplied
with the components for further information on
the operation.
Press FUNCTION +/– repeatedly until
“VIDEO1”or “VIDEO2”appears in the front
panel display.
Each time you press FUNCTION +/–, the mode
of the system changes in the following sequence.
DVD t TUNER FM t TUNER AM t
VIDEO1 t VIDEO2 t TV t AUDIO t
DVD t …
Note
• When you use both the VIDEO 1 (AUDIO IN) jacks
(analog connection) and VIDEO 1 (DIGITAL IN
COAXIAL or OPTICAL) jack (digital connection),
or the VIDEO 2 (AUDIO IN) jacks (analog
connection) and VIDEO 2 (DIGITAL IN COAXIAL)
jack (digital connection) at the same time, the digital
connection takes priority.
Changing the input level of
the sound from connected
components
You can change the input sensitivity of the
AUDIO IN (VIDEO 1, VIDEO2, TV) jacks on
the rear panel and the AUDIO jack on the front
panel.
1
Press FUNCTION +/– repeatedly until
“VIDEO1,” “VIDEO2,” “TV,” or
“AUDIO” appears in the front panel
display.
2
Press AMP MENU.
3
Press X / x repeatedly until
“ATTENUATE” appears in the front
panel display, then press
or c .
4
Press X / x to select a setting.
• ATT ON: attenuates the input level. Set
this if distortion occurs during listening.
• ATT OFF: normal input level. Set this if
the input level is low.
5
Press .
6
Press AMP MENU.
The AMP menu turns off.
Selecting the Component
AMP MENU
X/x/c ,
FUNCTION
+/–
With the cover opened.