Sony STR-DE345 - Manual (Page 8)

8 US
Getting Started
Hookups
Front Speakers
Rear and center speakers
To avoid short-circuiting the speakers
Short-circuiting of the speakers may damage the
receiver. To prevent this, make sure to take the
following precautions when connecting the speakers.
Make sure the stripped ends of each speaker cord does
not touch another speaker terminal or the stripped end
of another speaker cord.
Examples of poor conditions of the speaker cord:
Stripped speaker cord is touching another speaker
terminal.
Stripped cords are touching each other due to excessive
removal of insulation
Front speaker
(R)
Front speaker
(L)
Receiver
SPEAKERS
REAR
L R
CENTER
Receiver
Rear speaker
(R)
Rear speaker
(L) Center speaker
Receiver
Active Woofer
FRONT
SPEAKERS
–
R
L
+
–
FRONT
SPEAKERS
R
L
+
After connecting all the components, speakers and AC
power cord, output a test tone to check that all the
speakers are connected correctly. For details on
outputting a test tone, refer to ”Adjusting the speaker
volume”, on page 17.
If you have connected rear speakers, be sure to press
the 5.1 CH/DVD button and turn off sound field on
the receiver before outputting a test tone so that the
tone is output individually from the left and right rear
speakers.
If no sound is heard from a speaker while outputting a
test tone or a test tone is output from a speaker other
than the one whose name is currently displayed on the
receiver, the speaker may be short-circuited. If this
happens, check the speaker connection again.
Active woofer
Note
Do not connect any other component.
To listen to the speakers
Make sure that you set the SPEAKERS button to ON.
If your TV monitor uses separate speakers
You can connect one of them to the SPEAKERS
CENTER terminals for use with Dolby Pro Logic
Surround sound (see page 16).
Where do I go next?
To complete your system, go to “AC Hookups” on next page.
SPEAKERS
FRONT
R L
SUB
WOOFER
AUDIO OUT
INPUT