Sony HDR-AX2000 - Manual (Page 76)

76
LINKED ( )
Controls the audio level of CH1 linked
with that of CH2. Sound inputs from CH1
and CH2 will be recorded as a set of sound
such as stereo sound.
appears on the
status check screen.
b Notes
• This function is available when the CH1 and
CH2 switches are set to MAN and the INPUT1
and INPUT2 switches are both set to MIC or
both set to LINE (p. 39).
• When you select [LINKED], you can adjust the
volume with the AUDIO LEVEL dial of CH1
(p. 39).
x INPUT1 TRIM
You can adjust the input signal level from
INPUT1.
You can select from [-18dB], [-12dB],
[-6dB], [0dB], [+6dB] and [+12dB]. The
default setting is [0dB].
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
x INPUT1 WIND
B OFF
Disables wind noise reduction.
ON
Enables wind noise reduction.
appears on the status check screen.
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
x INPUT2 TRIM
x INPUT2 WIND
You can set INPUT2 in the same way as
INPUT1.
z Tips
• -48 dBu is set as 0 dB in your camcorder.
• Set INPUT TRIM to [0dB] for a microphone
(sold separately).
• The INPUT TRIM function adjusts the input
level from an external microphone. When using
a highly sensitive microphone or recording loud
sound, set this to the minus side. When using a
less sensitive microphone or recording quiet
sound, set it to the plus side.
• When recording loud sound, the sound may be
distorted at either the input point or the
recording point. If it is distorted at the input
point, adjust the sound using the INPUT TRIM
function. If it is distorted at the recording point,
lower the total volume level manually.
• If you set INPUT TRIM too far to the minus
side, the microphone volume becomes too low,
resulting in a poor signal to noise ratio.
• Test the effect of the [AUDIO SET] function
according to the microphone used or the sound
field of the recording site before actual
recording.
M
Press the MENU button t select (AUDIO SET) with the SEL/PUSH EXEC dial.