Sony STR-DN1030 - Manual (Page 90)

90 US
D:\NORM'S JOB\SONY HA\SO130039\STR-DN1030_PMRF
06\4420297142_US\US05ENJ_STR-DN1030-CEL.fm masterpage: Left
STR-DN1030
4-420-297-14(2)
Using a bi-amplifier
connection
1
Press MENU.
The menu is displayed on the TV screen.
2
Select “ Settings”, then
press or b.
The Settings menu list appears on the TV
screen.
3
Select “Speaker”, then press
or b.
4
Select “SP Pattern”, then press
or b.
5
Select the appropriate speaker
pattern so that there are no
surround back speakers and
front high speakers, then press
.
6
Select “SB Assign”, then press
or b.
7
Select “BI-AMP”, then press
.
The same signals output from the
SPEAKERS FRONT A terminals can be
output from the SPEAKERS
SURROUND BACK/FRONT HIGH/
BI-AMP/FRONT B terminals.
To exit the menu
Press MENU.
Notes
• Set the “SB Assign” to “BI-AMP” before you
perform Auto Calibration.
• If you set the “SB Assign” to “BI-AMP”, the
speaker level and distance settings of the surround
back speakers and front high speakers become
invalid, and those of the front speakers are used.
Using multi-zone
features
You can enjoy sounds from the equipment
connected to the receiver in a zone other than
the main zone. For example, you can watch the
DVD in the main zone and listen to the CD in
zone 2.
When using an IR repeater (not supplied), you
can operate both equipment in the main zone
and Sony receiver in zone 2 from zone 2.
To operate the receiver from
zone 2
You can operate the receiver without pointing
the remote control towards the receiver if you
connect an IR repeater (not supplied) to the IR
REMOTE jack.
Use an IR repeater when you install the
receiver in a place where signals from the
remote control cannot reach.