Sony LBT-GPX555 - Manual (Page 26)

model name [LBT-GPX555 / MHC-GPX888/GPX555]
[4-485-746-11(2)] GB
26 GB
filename[D:\NORM'S JOB\SONY HA\SO130081\LBT-GPX555MHC-
GPX888_GPX555 (PMRF 01)\4485746112\06BAS.fm] masterpage:Left
2
Press BLUETOOTH on the unit
to select Bluetooth function.
“BLUETOOTH” appears in the
display panel.
Note
If the system is connected to a Bluetooth
device, press BLUETOOTH to disconnect
the Bluetooth device.
3
Hold down BLUETOOTH on the
unit for 2 seconds or more.
“PAIRING” flashes in the display
panel.
4
Perform the pairing procedure
on the Bluetooth device.
For details, refer to the operating
instructions of your Bluetooth device.
5
Select the model number of the
unit on the display of the
Bluetooth device.
For example, select
“SONY:MHC-GPX888” (or
LBT-GPX555/MHC-GPX555).
If passkey is required on the Bluetooth
device, enter “0000”.
6
Perform the Bluetooth
connection on the Bluetooth
device.
When pairing is completed and the
Bluetooth connection is established,
Bluetooth device name appears in the
display panel.
Depending on the Bluetooth device,
connection may start automatically
after pairing is completed.
You can check the Bluetooth device
address by pressing DISPLAY
repeatedly.
Notes
• You can pair up to 9 Bluetooth devices. If the
10th Bluetooth device is paired, the oldest
paired device will be deleted.
• “Passkey” may be called “Passcode”, “PIN
code”, “PIN number” or “Password”, etc.,
depending on the device.
• The pairing standby status of the system is
canceled after about 5 minutes. If pairing is
not successful, repeat from step 1.
• While connected to a Bluetooth device, this
system cannot be detected and connection
cannot be established from another Bluetooth
device which is never paired before.
• If you want to pair with another Bluetooth
device, repeat steps 1 to 6.
To cancel the pairing operation
Hold down BLUETOOTH on the unit for
2 seconds or more until “BLUETOOTH”
appears in the display panel.
You can operate a Bluetooth device by
connecting the system and the Bluetooth
device using AVRCP.
Check the following before playing
music:
– The Bluetooth function of the Bluetooth
device is turned on.
– Pairing has been completed.
1
Press BLUETOOTH on the unit
to select Bluetooth function.
“BLUETOOTH” appears in the
display panel.
2
Establish connection with the
Bluetooth device.
The last connected Bluetooth device
will be connected automatically.
Perform the Bluetooth connection
from the Bluetooth device if the device
is not connected.
Once the connection is established, the
Bluetooth device name appears in the
display panel.
3
Press N to start playback.
Depending on the Bluetooth device,
– you may need to press N twice.
– you may need to start playing an
audio source on the Bluetooth
device.
Playing music from a
Bluetooth device