Avocent Cyclades-PR4000 - Manual (Page 72)

72 Chapter 8 - The E1 and T1 Interfaces, With Signaling
Cyclades-PR4000
Wizards Menu CONFIG =>INTERFACE =>T1/E1 => <CHANNEL> =>WIZARDS
Menu Items Description
TS Profile Used to create a local host Terminal Server. For CCS, the only parameter is the
Username. For CAS, the parameters are the Username, the Phone Number for the
channel, and the Digital Modem Profile ID.
RAS Profile Used to set up a PPP Remote Access Server using modems and dial-up lines. The
Remote IP Address of the first port is the only parameter, for CCS. For CAS, the
parameters are
Remote IP Address, the Phone Number for the channel, and the
Digital Modem Profile ID. If the Wizard is used for a range or all ports, the following
ports will be the numbered consecutively.
Lan-to-Lan Profile Used to connect two LANs. The only parameters are the Primary IP Address, the
Subnet Mask, any Secondary IP Addresses and Subnet Masks, the Remote IP
Address Type and the Address. For CAS, the parameters Phone Number and Digital
Modem Profile ID are also requested.
Copy From Channel Used to copy an entire configuration from one channel to another, while changing the
IP address so that the ports are numbered consecutively.
The parameters automatically configured by the terminal server wizard are shown in Figure 8.11.
Encapsulation
Device Type
TCP KeepAlive
Terminal Type
Escape Session Character Code
Switch Session Character Code
Direct Login User
Dial-Out
Phone #
Digital Modem Profile ID # CHAR
Terminal
Inactive
ANSI
1
11
***
Non-Automatic (CCS only)
*** for CAS
*** for CAS
FIGURE 8.11 PARAMETERS SET BY THE TS WIZARD