Avocent Cyclades-PR4000 - Manual (Page 93)

Cyclades-PR4000
Chapter 11 - Routing Protocols 93
Unnumbered
Interfaces
Point-to-Point
Connection
Slot 1
ETH0
ETH0
Slot 3
Router 1 10.0.0.3
192.168.100.1
Router 2
A
B
E
F
Network 3
Network 1
FIGURE 12.2 STATIC ROUTING EXAMPLE 2
Figure 12.2 shows another static routing example to explain the Gateway or Interface parameter. Between the
two routers is a point-to-point connection. Another network could be created, but is not necessary. Both routers
can be assigned unnumbered interfaces, because everything that leaves one router is sent to the other.
To define static routes, enter the menu CONFIG =>STATIC ROUTES =>IP =>ADD ROUTE. A description of the
parameters in this menu, with the configuration for Router 1 in the examples above, is given in the table that
follows.