Sony SU-WH500 - Manual (Page 4)

4
(GB)
• Be sure to have the TV’s operating instructions, the supplied
“Installation Guide,” a Phillips screwdriver, and an electric drill
before installation.
• If you use a supported TV model that is not described in this
manual, check the installation procedure by referring to your TV’s
operating instructions.
• Refer to the “Installation Guide” when there is a mark
appended to the procedure.
~
Keep small children away from the small parts to prevent accidental
swallowing.
Preparation
Check the supplied items
A Wire Bracket ×1
B Pulley ×2
C Tilt-up Bracket ×1
D Belt Bracket ×1
E Support Belt ×1
F Anchor A ×6 (Spare ×1)
G Wood Screw (
φ5Ч65)
Ч6 (Spare ×1)
H Anchor B ×6 (Spare ×1)
I Screw (M5Ч60) Ч6 (Spare ×1)
J Screw (M6Ч18) Ч4
K Cushion A ×4
L Cushion B ×4
M Paper Template ×1
N Installation Guide ×1
O Instructions
(this manual) ×1
Installation
1 Decide on the installation location
1
Decide on the center position of your TV.
Make a mark on the Paper Template M that indicates the screen
center of your TV, referring to the Screen center dimension C in
“TV installation dimensions table” at the end of this manual.
2
Tape the Paper Template to the wall.
Decide on the installation location, referring to your TV’s
dimension and the screen center mark on the Paper Template M,
and tape the Paper Template M to the wall.
Allow for suitable clearance between your TV and the ceiling and
protruding parts of the wall as shown below to the left. Never
install your TV as shown below to the right:
~
If you intend to route the cables into the wall, make a hole in the
wall to insert the cables before beginning the installation.
2 Install the Wire Bracket on the wall
WARNING
The wall that the TV will be mounted on should be able to support
a weight of at least four times that of the TV. (Refer to your TV’s
operating instructions for its weight.)
Determine the strength of the wall the TV will be mounted on.
Reinforce the wall sufficiently, if necessary.
1
Make holes for installing on the wall.
Make four holes at the marks on the Paper Template M using an
electric drill.
A For thick walls
Make holes 65 mm (2 5 / 8 inches) deep in the wall using a 9 mm
( 3 / 8 inches) electric drill. This is for a standard installation.
B For thin walls
This is for a sturdier installation using the Anchor B H. Make
holes only in the superficial area of the wall using a 13 mm
(
17 / 32 inches) electric drill.
Air circulation is
blocked.
Wall
100
(4)
100
(4)
300
(11
7
/ 8
)
10
0
(4
)
Unit: mm (inches)