Call log messages – ADTRAN L128 User Manual

Page 142

Advertising
background image

Appendix B: Log Messages

61202.070L1-1

Express L128/L128T User Manual

125

Peer failed PAP authen
level 3
The PPP peer’s reported PAP username and/or password does not match the
Express L128/L128T’s parameters. This is most likely caused by PPP peer
sending incorrect username and/or password. Make sure the Configuration/
Connection List/Authentication

parameters Rx Username and Rx Password

are correctly entered. Also, if using RADIUS, check that the server is config-
ured and running properly.

Peer refused authen
level 3
The PPP peer would not allow the Express L128/L128T to authenticate it using
the method set in Configuration/Security/PPP.

Peer refused SpanTree
level 4
The PPP peer would not participate in the Spanning Tree protocol. This is a
warning message only. Bridging will still occur across the WAN port so care
must be taken that no loop topologies exist across the connection.

PPPtx[x] …
level 6
Advance debugging decode of transmitted PPP configuration packets.

PPPrx[x] …
level 6
Advanced debugging decode of received PPP configuration packets.

Call Log Messages

Answer <number>
level 5
An incoming call from <number> was answered. If no caller ID is available
for the ISDN line then <number> will be blank.

AutoSpid Download Not Available
level 4
Lucent AutoSpid download is not available from this ISDN switch.

AutoSpid Download Pass
level 4
Lucent AutoSpid download feature has successfully installed the SPIDs.

Advertising
This manual is related to the following products: