Or raise mower. use protective device, Springs weak. replace springs, Improper adjustment. re-adjust slip clutch – Alamo A84B User Manual
Page 135: Too much power for reduce ground speed and, Slip clutch. material intake, Friction facings worn. replace facings, Oil on facings. replace facings, Friction facings glazed. clean with emery cloth, Approximately 5/8, Oil level too high. lower oil level to plug
OPERATION
A84B 03/07
Operation Section 4-45
© 2007 Alamo Group Inc.
OPERA
T
ION
SHAFT OR TUBE TWISTED
Over-loaded.
Replace part and then slow down or
or raise Mower. Use protective device.
TUBE BROKEN IN WELDED
Over-loaded.
Replace part.
SEAM
YOKE BROKEN AT
Over-loaded.
Replace part.
EAR TIP
SLIP CLUTCH SLIPPING
Excessive load.
Reduce speed and/or raise cutter.
EXCESSIVELY
Springs weak.
Replace Springs.
Improper adjustment.
Re-adjust Slip Clutch
Too much power for
Reduce ground speed and
Slip Clutch.
material intake.
Friction Facings worn.
Replace Facings.
Oil on Facings.
Replace Facings.
Friction Facings glazed.
Clean with emery cloth.
OIL BLOWING OUT
Flat bottomed Vent Plug
Replace with proper Vent Plug.
VENT PLUG
or shallow cavity Plug.
Cavity in Oil Plug should be
approximately 5/8".
Oil level too high.
Lower oil level to Plug.
DRIVELINE INTEGRAL
Integral Shields deformed.
Replace Shield.
SHIELDS RATTLING OR
NOT TURNING FREELY
Nylon Bearing worn.
Replace Nylon Bearing.