Alamo A84B - Manual (Page 82)

ASSEMBLY
A84B 03/07 Assembly Section 3-4
© 2007 Alamo Group Inc.
ASSEMBL
Y
SINGLE TAIL WHEEL ASSEMBLY - LIFT TYPE Figure Asm-R-0125.
Insert bushing (2) in lug centered behind gearbox. Attach the tailwheel beam (1) to the lug on the mower deck
using bolt (3) and locknut (4).
Attach the brackets (5 & 6) to the main deck using bolts (8), washer (9), & nuts (10). Note: Formed leg with
adjustment holes must point to rear and should be on each side of tail wheel beam.
Install bolts 11) & nuts (12) on top and bottom of tailwheel beam. Insert through pair of holes which will give
approximate desired cutting height. Tighten all bolts per Torque Chart.