Asante Technologies 1012 - Manual (Page 20)

Page 1-8
Chapter 1 — Quick Start
Bridge External Port Status LED
There are three separate LEDs:
RCV flashes when a packet is received on the external port.
FWD flashes when a packet is forwarded from the hub port to
the external port.
COL flashes when a packet collision is detected on the bridge
external port.
Bridge Spanning Tree Status LEDs
STATUS flashes when the bridge is still alive in the spanning
tree configuration.
STANDBY is on when the bridge is on standby or blocking in
the spanning tree.
ACTIVE is on when the bridge is the active or forwarding
bridge in the spanning tree.
Bridge Hub Port Status LEDs
There are three separate LEDs:
RCV flashes when a packet is received on the hub port
FWD flashes when a packet is forward from the external port to
the hub port.
COL flashes when a packet collision is detected on the bridge
hub port.
RJ45 Port Connectors
These are the twelve 10BaseT ports provided by the hub; each
port can be connected to an Ethernet device, including another
hub.
Figure 1-4 AsantéBridge 1012 Front Panel
ASANTE
RESET
PWR CPU
SNMP MSG
UTILIZATION
%
PARTITION
LINK/RECEIVE
BRDG 1
1
10BASE-T PORTS
AsantéHub 1012
1 3 5 10 20 30 50 65+ UPLINK 2 3 4 5 6 7 8 9 10 11 12
2 3 4 5 6 7 8 9 10 11 12
COLLISION
%
1 3 5 10+ Late Collision
Misaligned CRC
Runts/Fragments
Short Event/Missing SFD
STATUS STANDBY ACTIVE RCV FWD COL
BRIDGE
RCV FWD COL
BRIDGE 0000944007B3
EXT PORT HUB
Reset
Button
Physical
Address
Power LED
CPU Activity
LED
SNMP Agent
Activity
MSG LED
Hub Status LEDs
Hub Utilization
LEDs Uplink
Partition LED Port
Partition LEDs
Port Link/Receive LEDs
Bridge/Uplink Link/Receive LEDs
Bridge External
Port Status LEDs
Bridge Spanning Tree
Status LEDs
Bridge Hub
Port Status LEDs
RJ45 Port Connectors